According to manual, AD9880 has an ability to generate YCbCr 4:2:2 16 bits output on RED, GREEN ports with BT.656 SYNC.
Is this operation mode compatible with BT.1120 ? In addition, where is the exact timing and description of output data format.
The delay to place markers can be defined like this:
Hello. Please see the following thread:
I believe that this answer applies to AD9880 as well but please let me confirm.
Thread 18178 is not helpful to me.
According to maual page 46, there seems to be configuration for using BT.656 output.
This bit enables the output to be BT.656-compatible with defined SAV and EAV controls to be inserted.
These require specification of the number of active lines, active pixels per line, and delay to place these
Active lines and pixels maybe configured with registers from 0x2A to 0x2E.
How can I configure "delay to place markers" ?
In addion, I'd like to use YUV 4:2:2 16bits output mode. Which data port deliver markers ?
Retrieving data ...