We are loading the RF LO frequencies using console port. Here want to observe the Tx quad calibration, for this we have loaded RF LO frequency 1310mhz and it is different from the power on TX RF LO frequency that is 2400Mhz. As per procedure it should call the TX quad cal function after LO loading. But it is not entering into “AD9361_do_calib_run” function. We are monitoring the 0XA7 for TX LO convergence and Tx SSB convergence and it appears always converged . Please clarify. We are using no-os software 2015 release. For your reference attached debug log captured on console port.