AnsweredAssumed Answered

The latest ADIsimPLL (4.20.02),  VCO section is not working correctly

Question asked by HowieB on Jan 3, 2017
Latest reply on Jan 4, 2017 by PeterW

If I use custom VCO, the Phase noise section is not getting read  - report is blank in the noise section.

If I try using a library VCO, it doesn't work. I created a VCO in "VCO library editor" made sure that the ranges were correct - Tuning graph is correct, but simulatipon will not accept the VCO even though the required range is smaller than the VCO range.