I have a question about ADL5315.
I'm looking at the voltage to current converting (BIAS CONTROL INTERFACE, Datasheet Page 10)
I will measure the sensor voltage and control the current.
If measured sensor voltage is higher than VSET, control the current to be lower.
If measured sensor voltage is lower than VSET, control the current to be higher.
1. Can it be possible to control the Iout current by measuring sensor voltage?
2. How to expect IOUT current with regard to VSET?
3. Could I connect IOUT to the load to supply current?
4. In this condition, How to connect SREF pin?