Is it possible to load a Fast Lock profile after a power cycle without requiring full startup calibrations? I am attempting to minimize time to acquisition after applying initial power to the AD9361.
Fast lock profile stores the synthesizer calibration values that help in faster switching between different frequencies. When a chip is powered on there are initialization calibration and that you need to do on each power on. You cannot use fastlock for initialization calibration.
Please refer UG-570 page 7.
Initialization calibrations are calibrations that must be run each time the AD9361 device is powered up or hard reset using the RESETB pin. Several of the calibrations only need to run once during initialization and do not re-run during operation.
Retrieving data ...