I have a question about the ADXL362.
I use the ADXL362 in the stream mode.
Does this mode support the FIFO_OVERRUN bit?
Or, in this mode, is only the FIFO_WATERMARK bit supported?
I am using ADXL362 in the stream mode.
I set the FIFO_CONTROL and INTMAP1 register of ADXL362 as follows.
FIFO_CONTROL register(Address 0x28) = 0x02 （ = stream mode)INTMAP1 register(Address 0x2A) = 0x08 ( = FIFO_OVERRUN)
Afterwards, I set 0x02 to the POWER_CTL register, and started measuring.
However, interrupt did not occur.
I changed the FIFO_CONTROL and INTMAP1 register to the following settings.
FIFO_CONTROL register(Address 0x28) = 0x01 （ = Oldest saved mode)INTMAP1 register(Address 0x2A) = 0x08 ( = FIFO_OVERRUN)
In this setting, interrupt occurred.
As a result, I think the FIFO_OVERRUN interrupt to be not supported in stream mode.
Is this correct?
Retrieving data ...