We are using a FMCommS4 board with a Zedboard under your Linux distribution. This evaluation board integrate the AD9364 Transceiver. This transceiver is suposed to have a DAC up to 320 MSPS and a ADC up to 640 MSPS. However, we can only get a data stream up to 61.44 MSPS.
Is it posible to get a 320 MSPS data stream ?
How can we configure the module to get a faster data stream ?
We have seen in this web page AD9361 high performance, highly integrated RF Agile Transceiver™ Linux device driver [Analog Devices Wiki] , that there are two low-pass filters in the RX/TX signal path and we can configure its sampling rate up to 122.88 MSPS if we select 1RX1TX interface.
The AD9364 is a 1 RX / 1 TX Transceiver so, How can we configure the Baseband Filter in order to get a samplif rate of 122.88 MSPS ?
Javier Nunez Sanchez