I have question about ADL5502 datasheet P5 "Peak Hold time".
The datasheet has Peak Hole Time.
In this section has "CNTL=high". For peak hold, CNTL should be "Low".
How should I understand the explanation?
Thanks and best regards,
The "CNTL = high" condition is a typo. To be in peak-hold mode, CNTL needs to be low. So what the spec is saying is the following. At time = 0 s, with CNTL low, lets say that the output catches a peak of 1V. No further peaks occur which are bigger than this peak in the immediate aftermath. At time = 600 uS, the peak voltage on the output will have drooped to 990 mV or by 1%.
Thank you so much!
Retrieving data ...