I bough a HSC-ADC-EVALCZ capture board plus a AD9251 EVL. I wonder whether the start sampling signal is told to AD9251 through SPI? I need to output this signal through J5 and J7 simultaneously.
The FPGA designer said that the write signal appears on the WEN line coming out of the Cypress USB controller on the HSC-ADC-EVALCZ. This signal is on U3 pin 70, and it goes through series resistor R36.
Can you access this signal and use it in your system?
The AD9251 SPI is used to configure the ADC. When power and the clock are applied to the ADC, it is running continually. The AD9251 does not receive the start-sampling-signal by SPI.
The FPGA receives the start-sampling-signal from your PC. I believe a new FPGA program would be needed to output the start-capture signal through J5 and J7.
Unfortunately I do not know of an FPGA program that outputs the start-capture signal through J5 and J7. I'll check with the FPGA designer for suggestions. Please note that he is currently out-of-the-office so it will probably be about 1.5 weeks before I can get back to you.
Thank you so much !
I am waiting for you.
Retrieving data ...