My supplies as below
AVSS = -13V
AVCC = +18V
VREF = 5V
OFFSET_DAC_CODE = 42130 (0xA492)
according to the datasheet(Rev.E) on page 39, about calibrate the force current,
In FI mode, when I write zero-scale and full-scale, do I have to use R Load?
if NOT, I always got the same measure from MEASOUTx
if YES, it clamped by clamp function, I couldn't get the desire zero-scale and full-scale.
it would be over range at MEASOUTx if I disable clamp function.
Can someone give me some suggestion or detail about this. thanks for all.