AnsweredAssumed Answered

ADuCM360 Clear UART Interrupt Flags

Question asked by lee_trieu on Jun 24, 2016
Latest reply on Jun 24, 2016 by lee_trieu


Hello everybody,

Is there any way to clear UART interrupt flags ?

My application usually run into UART Interrupt handler, then i read COMIIR register and get 0x06. I think this value is RX and TX interrupt flags.

After get UART data I use below command for clear UART interrupt flags.

pADI_UART->COMIIR = 0; // Clear UART Interrupt Flags 

I don't found exactly command for clear UART interrupt flags on almost examples. 

Thanks !

Outcomes