I am using AD9361 in muliple-channel application where synchronization of the channel is improtant.
When I do channel calibration, I found the received data from the two channel sometimes have a delay of 1 sample. Then, I want to check if my FPGA interface has timing issue. Therefore, I use the BIST fuction to generate data patterns internally from AD9361.
I want to confirm that if I set to BIST mode, are the RX data from the two channels synchronized or NOT ?
In other words, Should I expect the same output from the two channels or not?
0x3F4—BIST Config is set to 0xC3.