In debugging I noticed the good debug starts with this :
Sometimes I get this and if I continue seccion will stop at fatal error , I need to reset the board and restart the debug:
What can be the cause?
We cannot simulate this issue.We have checked here and we don't see any fatal error or software crash.
Please take a look at the below linked FAQ which might help you:
FAQ: Reporting a Crash or Hang in CrossCore Embedded Studio
Can you please share us your project along with the steps to replicate your issue so that we can assist
Please also check the below FAQ:
FAQ: Debugging on ADSP-SC58x / ADSP-2158x Targets
As we checked here we cannot build the project successfully that you have shared. Please see the attached screenshot.Can you please share us the project that compiles without any error.
This is ADI project with no change, but it compiles with 2.1.0 crooscore.
We cannot simulate this issue and we have checked here with CCES 2.1.0,SC584 EZ kit and we can debug and load the program successfully. Please see the attached screenshot. Please share us your steps to replicate this issue.
I tested this a few more time , this issue happens most of times .
Also if I hit a breakpoint or halt core0, then try to resume software crashes and stops at "fatal error".
We are going to buy more Evaluation boards , I will test with them when arrived.
I assume something is wrong with my setup (ICE-1000 1.1) or else in case you don't see any problem.
Retrieving data ...