Dear sir, I need to amplify a signal of 0-100 mV to 0-1 V. I'm using AD623 with gain 10. + Vs=5; -Vs=0. I do not get this gain . Might be wrong ?
What is your common mode voltage?
What is the differential voltage?
Where is the REF pin?
Use the diamond plot tool: Instrumentation Amplifier Diamond Plot Tool | Analog Devices
Hi harryh, i attached a schematic.
Gain must be 10. I only get 8.5.
Thanks for your help.
What's the common mode voltage? Can I assume that running on ground and 5V, the
differential outputs sit at 2.5V and then go 50 mV up or down with pressure?
Retrieving data ...