AnsweredAssumed Answered

Tracking Filter Boost/Cut Resets Itself

Question asked by Austin on Jul 19, 2011
Latest reply on Sep 1, 2016 by Jackie

I'm using the Tracking Filter block in a program and every time I re-launch SigmaStudio, the boost or cut of the filter goes back to zero. I'm positive I'm saving it, and all my other paramaters are fine (Q stays constant, gain is at 0 anyway, other blocks and filters don't have an issue) I can set them and while I'm in the program everything is working correctly, but if I save and exit (either close the project or SigmaStudio entirely) they go back to 0 booost/cut the next time I open the project.

 

I have two tracking filters in the circuit and both have the same issue, I seem to remember running into this problem before, but I can't be sure, and I don't remember solving it. Any ideas on what my problem might be?

 

SigmaStudio 3.4 ADAU1701 Windows 7

 

Thanks.

Outcomes