We are using AD9361 on ZynQ Base board. For the purpose of programming the AD we downloaded the prebuilt images form the AD wiki.
We could get the IIO-Scope GUI with prebuilt package (2015_R2-2016_04_01.img.xz) on Zynq(ZC706)+AD9361 setup
On that package I replaced the uImage with the debug build of "linux-2015_R2.zip". Where We have added
printk statement in ad9361_spi_write() for capturing reigster write sequence.
With this custom build, we are able successfully plot the waveform on the GUI and capture the spi_write dumps only during boot up.
However run-time configuration of AD through GUI does not show any spi_write messages on serial console.
Please help us on this.