Good day, I am looking for an example ,can someone show an example using ADAU1701 and the SSM2518....... Thanks in advance ...
This is pretty straightforward. You distribute the master clock, MCLK, to both parts. Then use the multi-function pins on the ADAU1701 to produce LRCLK, BCLK and the serial data out. The serial output port is setup using register 2078 (0x081E). Set it up to be a master. See table 64 in the 1701 datasheet. It shows that the LRCLK will be on MP10, BCLK is on MP11 and SDATA_OUT will be on MP6.
Configure the serial port for I2S.
For the SSM2518 I suggest you run it in Standalone mode. This will be the simplest. Look at the Standalone section of the datasheet (Page 17) for details.
Retrieving data ...