AnsweredAssumed Answered

Configure parallel data ports with API no-OS

Question asked by vit3d@mail.ru on Apr 11, 2016
Latest reply on Apr 12, 2016 by DragosB

Hello, everyone!

I have self board with ARM MCU and FPGA for communication with AD9361.

I porting no-os software to ARM MCU and I can configure transceiver with SPI cross

FPGA.

System successfully configured and start AD9361. I use no-os software API for operational with AD9361, but in this software absent functions and init parameters for configuring parallel data port!?

There is only ENSM state config and some init parameters.

How can I check the current mode of a parallel data port and configure it!? Sample (SINGLE PORT HALF DUPLEX MODE, DUAL PORT HALF DUPLEX MODE, DUAL PORT FULL DUPLEX MODE and etc.)

Outcomes