katsu

ADAU1361 Trouble to use SPI mode

Discussion created by katsu on Mar 30, 2016
Latest reply on Apr 21, 2016 by Hirossan

Hello,

 

Facing a trouble to use SPI mode. To solve the problem could you please answer to following questions?

 

Q1. Does communication speed need to be lower than 400kHz to move to SPI mode after Power up?
Q2. At what timing does communication speed need to be changed to use SPI mode in MHz order? Is immediately after pulling CLATCH_B low three times right timing?
Q3. In case that I2C start condition (a high-to-low transition on SDA/COUT while SCL/CCLK remains high) is satisfied accidentally after Power Up, is it impossible to move to SPI mode?

 

Best Regards,

Outcomes