AnsweredAssumed Answered

ADAU1966 evaluation board not getting PLL clock

Question asked by sha@hys on Mar 22, 2016
Latest reply on Mar 24, 2016 by DaveThib

Hello,

 

                   I brought ADAU1966 evaluation board. I am using ARWB software with I2C to communicate with board. I was able to read and write to registers successfully. Initially I programmed all registers to reset state. then I made power up bit 1 in PLL_CLK_CTRL0 register that is  programmed to 01. I have given oscillator as clock source. I am able to see clock at TP20 clk_out point. But I am not getting master clock at MCLK pin in JP2 (Figure 14 in evaluation board user guide).I think  I am supposed to get it there.Why is this happening??

 

                    Actually I wanted to use board with my clocks and DAC inputs (not for audio stream). So I was doing this. Do I have to program any other register to get the MCLK for loop filter.

 

With Regards

Shalini

Outcomes