Would you please help to provide ADV7181D 480P RGB graphic mode registers setting?
I believe the settings for the ADV7181D are available in the ADV7181D_ADV7181D@_ADV7341-VER.1.0c.txt script files ( https://ez.analog.com/docs/DOC-2002). Did you refer those?
Yes, I have seen the script file, but the input signal is "Graphic RGB 480P" signal, not "YPrPb component 480P" signal,
so the settings
:525p/60Hz YPrPb In 8Bit 422 HS/VS Encoder" is not suit for the Graphic RGB signal input signal.
I think if it should be use auto-graphic mode for non-standard to handle this Graphic RGB 480P timing?
Would you please help to provide the settings for this condition?
Have you referred the below thread also?
The thread you mention about is seem not in relation to auto graphic mode for RGB 480P settings, could you please provide the thread which for RGB 480P auto graphic mode setttings?
We have asked an expert on this part to take a look and reply.
As per the expert comment, unfortunately we do not have settings for that mode. The modes supported for the ADV7181D are the modes available in the ADV7181D_ADV7181D@_ADV7341-VER.1.0c.txt script files. These are the modes that were fully evaluated and for which support is provided.
Please refer to this thread: https://ez.analog.com/thread/80712
The ADV7181C_RGB_SOG pdf provided there could be a starting point for you. It is for 525i RGB. You might use that as a starting point, following the guidelines in that thread. That’s the best we can provide.
Retrieving data ...