I am working on a circuit where the AD8021 will be driving a 300 ohm load at about 20V p-p .
To dissipate power, I want to make some of the PCB traces very large.
check my reasoning:
+in and -in should not be made large because stray capacitance on the signal inputs is undesirable.
Likewise for the compensation pin.
These traces can safely be made large:
+Vs , -Vs, shutdown, logic reference.
Output pin must have a long trace, but extra C here is also not desirable, but less problematic than for signal inputs and compensation pins.
What am I missing?