npn98

Re: ADALM1000 doesn't turn on after attempted firmware update

Discussion created by npn98 on Mar 6, 2016
Latest reply on Mar 8, 2016 by dmercer
Branched from an earlier discussion

Hi dmercer,

I'm having a similar problem with my ADALM1000 except I'm not seeing any signs that Windows is detecting it and BOSSA isn't picking it up either. However, instead of having a failed update using Pixelpulse, I used BOSSA to start. Following the instructions, I put the device into reset mode but BOSSA still didn't pick it up (this was on a Mac). Prior to the attempt, alice was not detecting the device either (on the same Mac). I've tried switching it to a few different computers now (including a Windows computer with Pixelpulse and BOSSA) but none of them have detected the board. Any suggestions?

Thanks,

Noah

Outcomes