AnsweredAssumed Answered

Amplifying and offsetting

Question asked by BP2015-MDC on Jan 19, 2016
Latest reply on Jan 20, 2016 by richardcer

Hello I am quite new to the Opamp business, so bare with me.

 

1 I am getting a -10 to 10V signal over a BNC connector 50 ohm.

2 Then I would like to use a voltage follower followed by a voltage divider to reduce the signal to -1.5 to 1.5V.

so far so good.

 

3 After this I would like to offset the voltage signal with a Reference of 1.5V.

 

I have read that using a voltage divider and a inverting opamp causes a new thevenin voltage that reduces my amplification. would it be advisable to use another Voltage follower to prevent this? just to seperate the gain and the offset circuit?

 

for Opamps I would like to use the AD711

Outcomes