I would like to run the AD9361 in a receive only mode. What do I need to do to disable the Tx side of the chip to obtain the lowest possible power? If you could give me the exact register to write, that would be appreciated.
Please see: https://ez.analog.com/message/200661#200661
If you use the search function you will find other posts Rx only and power consumption related.
You should at a minimum disable both transmitters (Reg 0x002). Registers 0x050 - 0x058 contain power down control bits for many of the blocks on the chip. You can take a look at these bits and based on their descriptions power down blocks that are not required for your application.
Direct SPI Write applications are not supported on Engineer Zone due to the number of requests and complexity of the part. Please use ADI provided drivers to configure, initialize and operate the part.
Retrieving data ...