My AD9910 Evaluation board Z (Rev.G) worked fine when interfacing with an older computer running on Win XP.
In order to be able to use the board with a 64 bit interface on my new computer (Windows 10) I reprogrammed the board.
I used the USB Evaluation Board Programmer.
After programming, using the button Read EEPROM, I get following details:
Board Identity: AD9910 Eval Board (32/64-bit)
CO 56 04 24 EE 01 00 00 10 99 AD 00 00 00 00 00
*Programmer firmware has been installed, cycle power to restore
the boards functionality.
After cycling the power, I ran the evaluation software.
The green LED is blinking. Cyusb-1 is found, but the AD9910 is not found. See the screenshot below.
The jumpers on the board are set as advised by mcee.
IN - W3, W5, W6
EN - W1, W2, W4
What to do?