AnsweredAssumed Answered

Incorrect work of Timer1 after stop mode.

Question asked by Rasul on Jun 16, 2011
Latest reply on Jun 17, 2011 by Rasul

Hi!

I'm just a student finishing my thesis project. I use ADuC7026 in my designe.

I encountered a small problem.

After measurement by my device is done it goes into the stop mode. Because of unknown for me reasons after waking up by IRQ0 GP Timer (Timer1) works incorrectly.

May be some hardware nuance here?

And here's second question. How i can reset ADuC by software?

 

Best regards.

P.S. Forgive me for my English... I think i made a lot of mistakes here. English is not my native language

Outcomes