AnsweredAssumed Answered

Hello , I would like to ask a question on ADP5585.

Question asked by lux on Dec 9, 2015
Latest reply on Dec 16, 2015 by lux

Hello ,

My questions about the ADP5585  are follows . Your advice would be appreciated.

RST function

1) Can the RST pin be released ( set HIGH) as soon as the power supply voltage has been reached its specified value?

Or some wait time required ?

2)Assuming the power supply has been at the specified level , what would be the minimum  valid  RST Low pulse width?

3) What is the minimun required time before you can access the I2C registers after the RST has been brought HIGH?

Is the time "Delay from UNLO/ Reset inactive to I2C Access"  seen in the datasheet?

 

Regards,

Lux

Outcomes