AnsweredAssumed Answered

Data transmission start when using Simulink/libiio

Question asked by AndresTeleco on Dec 1, 2015
Latest reply on Dec 2, 2015 by CsomI

Hi,

 

I'm using a Zedboard, with the reference design from the hdl_2014_r2 release and the FMCOMMS3 evaluation board. The FPGA is connected to a computer running Simulink, in which I'm performing most of the signal processing.

 

Nevertheless, I need to know when a data frame when using Simulink is actually getting transmitted by the AD9361, so I was wondering if there is a signal at the programmable logic level of the FPGA indicating that a new frame of data is ready to get transmitted or similar.

 

Best regards,

 

Andrés

Outcomes