The customer would like to communicate with AD9361 (AD-FMCOMMS3-EBZ) via PMOD (SPI) from FPGA (Zynq).
Currently they not success to communicate above connection.
AD9361 and FPGA connection as below.
Other signals are not connected with FPGA.
1) Is these connection enough? Is anything else pins should connect?
2) At ADI sample soft, ResetB is connected GPIO. Is there any reset sequence required? (The customer connect Reset B to Zynq FCLK_reset0_N with 250u sec pulse width.)
Thank you for your help in advance.