AnsweredAssumed Answered

How to Target (Zynq Board) to Filter Design Wizard by MATLAB?

Question asked by yanjiesh on Nov 23, 2015
Latest reply on Dec 21, 2015 by dpu

Dear all,


As the title says, I tried to connect the target (Zynq Board)  when using Filter Design Wizard by MATLAB according to the relevant details on the web page of MATLAB Filter Design Wizard for AD9361 [Analog Devices Wiki].


However I failed, here are two photos I took in the experiment.

As shown in the photos, I set the IP4 address of Zedboard to, while my laptop which conneted to Zedboard via an ethernet cable had an IP4 address of


When I pressed the button of "Connect to Target" in the application of AD9361_Filter_Wizard, nothing further happened.


What was the reason why I failed?