I want to use the Indoor Occupancy Sensor in an overhead setup. How do I use one of the preset configurations to do this?.
The BLIP board can be set up such that the imaging sensor must be facing at an angle towards the field of view (perspective installation) or directly facing downwards at zero degree angle (direct overhead installation). The BLIP board has 2 sensors the ASX340AT and OVM7692. So select the desired sensor to be oriented correctly.
The ADVision Sensor Controller by default is configured for perspective view, hence if you want to change it for an overhead setup, you have to load the preset overhead configuration which is tailored for an overhead installation. To do this-
Retrieving data ...