Does the adv7611 need end of line termination on data lines that are going to
a few FPGAs. If need when using 50 ohm traces and 33 ohm series resistors
close to the ADV7611, what value should be used at the last FPGA. We are
using Forth software
Generally you don't need any end termination on the data line. The 33 ohm series resistors should suffice (can change to 22 also). As long as the runs are clean and relatively short you should not have problems. You may have to adjust LLC_DLL_PHASE when you get your prototype up and running at 1080p. Of course you can always run signal integrity on those traces.
Retrieving data ...