i have an issue with AD5064 DAC, it seems that i have constant ~+60[mV] offset to the output voltage.
i checked some info on calibration of the chip but there is nothing, any idea?
Offset error is measured as part of the final test program. Is the offset appearing on only one chip and is it on all 4 channels?
Can you post your schematic?
I checked it only on my prototype board. I'm writing to all 4 DACs, while two of them are not used.
Is it because of this? I'll try to write only to one DAC and see if it improved.
Any other suggestions?
Retrieving data ...