AnsweredAssumed Answered

Standard RMS block didn't show in capture

Question asked by Philip on May 19, 2011
Latest reply on May 25, 2011 by BrettG

I am using sigma studio 3.3. My project is to using small MCU to control the sigma DSP.

When I use the Standard RMS (Two channel compressor). I can not see the capture of the command and data send out. Any reason for that?

 

Another question is, for those ratio/threshold paramters, will the DSP get it directly? Or just the PC(Sigma Studio Software) convert to a 34 point table(like the 'Show Graph') and send to DSP ?

 

Thanks a lot.

Outcomes