AnsweredAssumed Answered

AD5933EBZ-Problem regarding admittance

Question asked by nazz3 on Oct 26, 2015
Latest reply on Nov 5, 2015 by LouijieC

Dear Sirs,

I am using the EVAL AD5933EBZ evaluation board with a resonance PZT sensor.  I also used an Agilent impedance analyzer to compare the results.  The impedance graph obtained is the same for both tests.  But surprisingly, the maximum admittance (minimum admittance) is not occuring at the same frequency.  I am using a calibration resistor of 30k ohms which is in the middle of the results obtained with the Agilent.

 

What are your suggestions I can do to obtain the same results?

 

I thank you in advance.

 

Best regards,

 

Niki

Outcomes