AnsweredAssumed Answered

Install GNU Radio on Linaro/ZedBoard/FMCOMMS3

Question asked by fpgaNoob on Oct 21, 2015
Latest reply on Oct 22, 2015 by fpgaNoob

I am attempting to install GNU Radio directly onto the Zedboard on a clean Linaro build which was built following this guide - https://wiki.analog.com/resources/tools-software/linux-drivers/platforms/zynq

 

I was hoping there was a repository available that would allow installation via apt-get but I don't believe I am that lucky. Is the only method of installation to cross-compile it? I see from previous posts ( https://ez.analog.com/message/175292#175292 ) that this is the preferred method in the past and a guide was generated. The guide however seems to be gone form the wiki, GNU Radio [Analog Devices Wiki] .

 

Basically, do I have to cross-compile and if so is my best bet to follow that previous forum discussion?


Thanks

Outcomes