I have a question.
ADAU1977 Datasheet p.4 says Single-Ended Input Voltage is 5 V rms.
I would like you to tell me what value of Voltage should be on AINx+ and AINx- on Figure 20 on p.20.
The input voltages need to stay between 0 and 14.14 V in order not to clip.
If you are planning on running the ADC single ended then the AINx- should be biased at half supply to give you your 5VRMS input range.
This is described in fairly good detail on page 19 of the data sheet.
Thank you very much for your answer.
I finally figured out what the data sheet is saying.
I will carefully read manuals from now on.
Retrieving data ...