I want to know the Pin status during the device is reset.
And I searched it in the engineer zone and find few discussion.
And I am trying to make the excel file about this.
What I want to know is
1) Is the pin is input or output when the device is reset ?
2) Is there any pull-up or pull-down to each pin for protect increasing the through-current?
3) What should we do when we don't use the pin?
INPUT pin => pull-down to GND or OPEN
OUTPUT pin => OPEN
I/O pin => OPEN
Is it correct?
3) And I would really appreciate if you don't mind to check the excel file.