Can we interface 4.3 Inch TFT LCD display directly with ADV7610/ADV7611 HDMI decoder chip.Its urgent..
Greetings of the Day!!!
I'm Dinesh Vinayak Katkar,from Robota Corporation ,Pune INDIA.We are developing one product in which HDMI input & USB touch Controller input is from Raspberry Pi.
In our board ,I have interfaced ADV7610 HDMI receiver and Audio Codec IC SSM2604 for speaker output.
I would like to ask you about design of ADV7610 , can we interface 24bit Digital output from ADV7611 HDMI receiver to the 4.3 inch LCD TFT Display NHD‐4.3‐480272EF‐ATXL#‐T.
All signals from ADV7611 is compatible to display interface or not.If yes ,then where to connect pin no. 31 (DISP ON/OFF) of 4.3 inch LCD TFT Display to HDMI receiver ADV7610.
I will be grateful if you could suggest me how to interface LCD Display directly to ADV7610 HDMI receiver.
Looking forward for your positive response.
The ADV7611 is basically a serial to parallel converter. So the input timing and format would have to match the LCD requirements. An initial look at the LCD data sheet shows its interface is just standard progressive RGB input with VS, HS and DE signals. This should connect directly to the ADV7611.
The ADV7611 can not control the DISP ON/OFF pin. This would need some other circuit.
Thanks for your prompt response.Shall I proceed with the Design with DISP ON/OFF pin controlling through other circuit design??
Looking forward for your reply.
Retrieving data ...