I was watching the data sheet.
And at data sheet REV.J , Figure.7 shows me the 8-bits output timing.
And I think this was changed at REV.J.
Why is this changed 16-bits to 8-bits?
I believe the figure was changed to reflect the 32 lead part which only has 8 pixel port pins. The RevH version reflects the 64 lead part with 15 pixel port pins. Regardless the timing applies to both parts and both pixel widths
Thank you for your answer.
So, is the REV.H for the 8-bit output and REV.J for the 16-bit?
I can understand that the timing is same between 8-bit and 16-bit,
but why the Figure 7 says only 8-bit?
If the timing is correct, I think the data sheet should say
" OUTPUTS P0 TO P7 or P0 to P15, HS, VS/FIELD/SFL"
Yes, the figure should be renamed as you suggested. This will not have a chance to happen until the next rev of the data sheet which has not been scheduled yet.
Thank you for your answer!
I under stood.
Retrieving data ...