AnsweredAssumed Answered

Trigger signal under 2-way Sweep mode of HMC703LP4E

Question asked by AkiraO on Aug 17, 2015
Latest reply on Aug 24, 2015 by rbrennan

Dear Sir,

 

We would like to get trigger signal under 2-Way Sweep mode.

When we set "ramp_busy" by Reg 0FH, we can get trigger signal from 5pin(LD_SDO). In taht case, the trigger signal is output every ramp-up and ramp-down. However, we would like to get trigger signal only ramp-up or ramp-dpwn. Are there any way for getting like that trigger signal?

 

And, when we use Eval Kit of  HMC703LP4E, LD_SDO ouput voltage was 2.0V(Low level) to 3.3V(High level). Is this normal operation? Are there any affect of interface board?

 

 

Best regards,

Akira

Outcomes