AnsweredAssumed Answered

ADIS 16000-16229 synchronous sampling

Question asked by herb on Aug 10, 2015
Latest reply on Aug 11, 2015 by NevadaMark


in the data sheet of the vibrations sensor system it is written that "Synchronous Data Capture at maximum sample rates" shoud be possible.

Our goal is to simultaneously acquire 512 acceleration samples with each of the planned 6 sensors 16229. These sensors then transmit their data to the 16000 gateway to finally arrive at the PC for data analysis.

In order to do detect vibration correlations at the different locations, the measurements of all 6 sensors have to be simultaneous.

Now however, I was not able to figure out a command that instructs all sensors to perform a manual measurement or, to trigger all sensors using something like a broadcast command. Neither was I able to find any number specifying the time jitter of the different sensors, when instructed to measure simultaneously.

This made me now doubt, whether such simultaneous measurements are possible at all.

Can anybody tell me how to do it or tell me that it is not possible?


Thanks a lot