I don't find in the register map reference manual what is the link between the capacitor register and the real value (p33).
Is there another way to program the filter ?
Are you currently using the ADI provided drivers to configure and use the part?
No, I don't use the drivers provided by ADI. The module I developed will be used by a third party without accesss to C++. Because the application is quite simple (CW signal, manual gain control), I though it would be possible to program the SPI without going through the driver.
Any algorithm or example for this kind of use case (almost a debug mode) ?
The settings to control the Tx BB filter are also missing (but the registers are available for the Rx BBF). Is there a reason why the filters are not given in Tx ?
Support on Engineer Zone relies on customers using the provided device drivers. Applications using direct SPI writes are not supported in this forum due to the part complexity.
Understood. But I don't understand why you give the parameters for the Rx and not for the Tx.
Anyway, I have an almost full sequence and I'll try to deal with it.
Retrieving data ...