AnsweredAssumed Answered

Question on Orinet Register

Question asked by Hide Employee on Apr 8, 2011
Latest reply on Apr 8, 2011 by jml

Hi

 

The follows is described in ADXL346 datasheet.

"Writing to the BW_RATE(Address 0x2C) or placing the part into standby mode rests the orientation feature, clearing the orientation filter and the orientation status."

I investigated whether Orient register is cleared or not .

In the case of setting BW_RATE=0x00 and standby mode,Orient register was cleared.

But in the case of setting excpt BW_RATE=0x00 ,Orient register was not cleared.

In addtion, when Overrun bit is set, Orient register is updated every time  interrupt generates.

Is it happen like the above event?

 

Thanks

Hide

Outcomes