Hi, I got some problem while using ADXL 375.
It doesn't give me 200G how hard I trys....And as the graph, it saturates at 25G.
I changed 0x31 Register, but it didn't work.
Please make sure the D3, D1 and D0 bit of register 0x31 are all "1". What is the raw data output when you shake the board? What ODR are you set? Could you share those?
What's more, I suggest you to use board to hit the table or ground, it can help to generate bigger acceleration than shaking the board with the hand.
The problem was that my FPGA isn't source out the right SPI commands while initiating.
I fixed that then it works fine.
Thank you for your attention and kindly answer.
Retrieving data ...