I am using TS101 in my design and now a little confused about the following two questions, could somebody give me some advice?
1, I connect CONTROLIMP0~2 with 111, I'd like to know what will happen to TS101.
2, Pins L2DIR and TMR0E are functioned as TM1 and TM2 under Strap mode, and 0 is required setting during reset, meanwhile, these two pins all have an 100 kilo-ohm pull down. Is that means these two pins can be unconnected? However, in EE-176 Table2, they are defined as "Pins that must be connected". How can I deal with them and what's the function of TM1 and TM2?
Thanks & Best regards,