Where is it possible to find the S-Parameters of the RF Output Ports for the ADF4350?
Thank you very much in advance!
S1P files attached for each of the power settings.
Thanks a lot for your quick answer, Ian!
Are these S-Parameters taken with 50-ohm resistors at the outputs to Vvco?
The s-parameters represent the ADF4350 output alone. The network analyser supplies the DC bias to allow accurate measurement of the small signal parameters of the ADF4350 output, and the PCB traces to the DUT are calibrated out.
it means pull up component at tested port is short to VCC?
Retrieving data ...