AnsweredAssumed Answered

Unable to connect to ADUC 7023 eval board using provided Midas-Link RDI JTAG

Question asked by furter on Apr 28, 2015
Latest reply on Apr 30, 2015 by furter

I can connect to the board using the application I2CWSD.exe, so I used it to mass erase the board. Then I downloaded the latest SEGGER J-LINK drivers (V4.98d), but I can't connect to the board using the provided RDI JTAG. Here is the message received from J-LINK commander with the command jlink.exe -device aduc7023 :

jlink.jpg

 

What am I doing wrong? The board is not in serial mode.

 

Thanks,

Cedric

Outcomes