I just need your comment here for ADP2503 Buck and Boost.
When your ADP2503 switch between Buck-mode and Boost-mode, can you keep the accuracy +/-3% Vout?
Input voltage=3.3V +/-5%
Output voltage=3.3V +/-3%, 0.1A
Your datasheet show "Output Voltage Initial Accuracy"=+/-2%
when Vout=3.3Vfixed ,Vin=3.6V fixed, Iout=no load.
But when you cross over Buck-mode and Boost-mode, what motion coming?
Can you keep above +/- accuracy?
Maybe we should try to study by doing eval board.
But I need your comment because our customer is worrying for this matter and urgent whether choice or not.
I need your good comment.